Search Results
Search results 1-2 of 2.
This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.
-
Quote from SEGGER - Nino: “Did you follow the steps explained in the SystemView user manual in section 3.11.3? Is your target device reset somehow so the SystemView data in RAM may become corrupted or deleted? ” Thank you for answer. Yes, I read this manual and when I included the SystemView code in my project, I took this point into account. Even when there is no reset, I cannot read the data: I start the project from the connected j-link and then halt it. The project, after resuming, is execut…
-
Hello, I`m using SystemView 3.10 with FreeRTOS 10.3.1 on STM32F756 with Nucleo board reflashed to J-Link OB. Start and stop Recording works fine: I see parts of log (with lost data) due to slow interface in J-Link OB. But I cannot read data recorded in post-mortem mode. I've tried to read data after target halting by IDE or Ozone and also tried to read data on running target after calling SEGGER_SYSVIEW_Stop(). I use the following configuration (except defaults): C Source Code (4 lines)When I pr…