Application log started
 - J-Flash V7.98h (J-Flash compiled Sep 11 2024 14:26:22)
 - JLinkARM.dll V7.98h (DLL compiled Sep 11 2024 14:25:50)
Reading flash device list [/opt/SEGGER/JLink/ETC/JFlash/Flash.csv] ...
 - List of flash devices read successfully (225 Devices)
Reading MCU device list ...
 - List of MCU devices read successfully (11420 Devices)
Creating new project ...
 - New project created successfully
Connecting ...
 - Connecting via USB to probe/ programmer device 0
 - Probe/ Programmer firmware: J-Link Ultra V4 compiled Sep 22 2022 15:00:10
 - Probe/ Programmer S/N: 504400379
 - Device "MIMXRT1175XXX8_M4" selected.
 - Target interface speed: 4000 kHz (Fixed)
 - VTarget = 3.323V
 - InitTarget() start
 - InitTarget() end - Took 1.47ms
 - Found SW-DP with ID 0x6BA02477
 - DPIDR: 0x6BA02477
 - CoreSight SoC-400 or earlier
 - AP map detection skipped. Manually configured AP map found.
 - AP[0]: AHB-AP (IDR: Not set, ADDR: 0x00000000)
 - AP[1]: AHB-AP (IDR: Not set, ADDR: 0x00000000)
 - AP[2]: APB-AP (IDR: Not set, ADDR: 0x00000000)
 - AP[1]: Core found
 - AP[1]: AHB-AP ROM base: 0xE00FF000
 - CPUID register: 0x410FC241. Implementer code: 0x41 (ARM)
 - Found Cortex-M4 r0p1, Little endian.
 - FPUnit: 6 code (BP) slots and 2 literal slots
 - CoreSight components:
 - ROMTbl[0] @ E00FF000
 - [0][0]: E000E000 CID B105E00D PID 000BB00C SCS-M7
 - [0][1]: E0001000 CID B105E00D PID 003BB002 DWT
 - [0][2]: E0002000 CID B105E00D PID 002BB003 FPB
 - [0][3]: E0000000 CID B105E00D PID 003BB001 ITM
 - [0][5]: E0041000 CID B105900D PID 000BB925 ETM
 - [0][7]: E0043000 CID B105900D PID 001BB908 CSTF
 - [0][8]: E0042000 CID B105900D PID 005BB906 CTI
 - Executing init sequence ...
  - Initialized successfully
 - Target interface speed: 4000 kHz (Fixed)
 - Found 1 JTAG device. Core ID: 0x6BA02477 (None)
 - Connected successfully
Erasing chip ...
 - 8192 sectors, 2 ranges, 0x30000000 - 0x3FFFFFFF, 0x60000000 - 0x6FFFFFFF
 - Start of determining flash info (Bank 0 @ 0x30000000)
 - ERROR: Timeout while preparing target, RAMCode did not respond in time!
 - ERROR: Failed to perform RAMCode-sided Prepare()
 - ERROR: Error while determining flash info (Bank 0 @ 0x30000000)
 - ERROR: Failed to erase chip
Disconnecting ...
 - Disconnected