Connecting ...
 - Connecting via USB to probe/ programmer device 0
 - Probe/ Programmer firmware: J-Link V10 compiled Jul 22 2022 11:40:29
 - Device "R7FA4M2AD" selected.
 - Target interface speed: 500 kHz (Fixed)
 - VTarget = 3.303V
 - ConfigTargetSettings() start
 - Configuring FlashDLNoRMWThreshold=0x200 in order to make sure that option bytes programming is done via read-modify-write
 - ConfigTargetSettings() end
 - InitTarget() start
 - Determining TrustZone configuration...
 -   Secure Debug: Disabled (NSECSD)
 -   Instruction set simulation: Disabled
 - Determining currently configured transfer type by reading the AHB-AP CSW register.
 - Transfer type does not match DLM state. Changing transfer type accordingly.
 - InitTarget() end
 - TotalIRLen = 10, IRPrint = 0x0351
 - JTAG chain detection found 2 devices:
 -  #0 Id: 0x6BA00477, IRLen: 04, CoreSight JTAG-DP
 -  #1 Id: 0x44002093, IRLen: 06, Unknown device
 - Failed to power up DAP
 - Connect failed. Resetting via Reset pin and trying again.
 - ConfigTargetSettings() start
 - Configuring FlashDLNoRMWThreshold=0x200 in order to make sure that option bytes programming is done via read-modify-write
 - ConfigTargetSettings() end
 - InitTarget() start
 - Determining TrustZone configuration...
 -   Secure Debug: Disabled (NSECSD)
 -   Instruction set simulation: Disabled
 - Determining currently configured transfer type by reading the AHB-AP CSW register.
 - Transfer type does not match DLM state. Changing transfer type accordingly.
 - InitTarget() end
 - TotalIRLen = 10, IRPrint = 0x0351
 - JTAG chain detection found 2 devices:
 -  #0 Id: 0x6BA00477, IRLen: 04, CoreSight JTAG-DP
 -  #1 Id: 0x44002093, IRLen: 06, Unknown device
 - Failed to power up DAP
 - ERROR: Failed to connect.
Could not establish a connection to target.