echo Setting up the environment for debugging gdb.\n

set complaints 1
set endian big
dir .
set prompt (ns7520) 

# listening for commands on this PC's tcp port 2331
target remote localhost:2331
monitor speed 30

# Set target to write short/long values in big-endian
monitor endian big

# Set GDB in big-endian 
set endian big

# Reset the chip to get to a known state.
monitor reset 1 0

# Set SCR for Big endian, full speed, 128 cycle Bus monitor
monitor long 0xffb00000 = 0x4004a000

# Setup DRAM refresh circuit
monitor long 0xffc00000 = 0x0dc00000

# Disable CS2
monitor long 0xffb00030 = 0x00000000
monitor long 0xffc00034 = 0x00000000

# The debugger script must clear the valid bit in CS0BAR.
# The ncc_init() routine looks at this bit to determine
# whether the unit is running under control of a debugger.
monitor long 0xffc00010 = 0x0

# Configure CS1 for 16 Megs of SDRAM
monitor long 0xffc00020 = 0x0
monitor long 0xffc00024 = 0xf3000170
monitor long 0xffc00020 = 0x0000022d
monitor long 0xffc00028 = 0x00000001

# Set the processor mode
monitor reg cpsr = 0xd3

# Setup GDB FOR FASTER DOWNLOADS
set remote memory-write-packet-size 1024
set remote memory-write-packet-size fixed
monitor speed auto

# Load the program executable called "image.elf"
load image.elf