Hello, I am having troubles programming flash on my AT91SAM3U4E device using Segger Microcontroller under Linux. I am using the GDBServer, and there is no problem loading the code to sram. Also, loading code to both flash and sram under Windows works fine, so this leads me to believe that the software package for Linux might be the core issue here. Could you please help me fix this?
My system:
SEGGER J-Link Edu V8.0
Software version: V4.36f
J-Link Firmware version: 2011 Sept 23
Development Board: at91sam3u-ek
Embedded code: yagarto.de/download/yagarto/SAM3U4ETest.zip
Attached:
jlink_error.txt -> error output, generated by JlinkGDBServer when trying to load code
flash.gdb -> gdb script, causing the error to occur under Linux
My system:
SEGGER J-Link Edu V8.0
Software version: V4.36f
J-Link Firmware version: 2011 Sept 23
Development Board: at91sam3u-ek
Embedded code: yagarto.de/download/yagarto/SAM3U4ETest.zip
Attached:
jlink_error.txt -> error output, generated by JlinkGDBServer when trying to load code
flash.gdb -> gdb script, causing the error to occur under Linux
The post was edited 1 time, last by mzakharo ().