Hello I managed to bring-up my J-Link EDU probe and attached it to my NXP imx31 board using an Olimex arm-jtag 20-10 pin adaptor. I made sure my configuration settings in Segger Ozone were properly set for imx31 with ARM6 instruction set. However I receive the following error when attempting to connect:
J-Link: Could not measure total IR len. TDO is constant high.
Connection failed
I also noticed that the status light on the J-Link is orange which I heard is an indicator that the reset pin is being held high on the device side. I assume that the J-Link cannot connect properly if it's being held in reset state. Can anyone please provide possible diagnoses?
Attached is a screenshot of the JLink.exe application output.
J-Link: Could not measure total IR len. TDO is constant high.
Connection failed
I also noticed that the status light on the J-Link is orange which I heard is an indicator that the reset pin is being held high on the device side. I assume that the J-Link cannot connect properly if it's being held in reset state. Can anyone please provide possible diagnoses?
Attached is a screenshot of the JLink.exe application output.