Hello,
I own a LPC-Link-2 probe that initially enumerate on USB bus in DFU mode with the following information:
idVendor=1fc9, idProduct=000c
Product: LPC
Manufacturer: NXP
SerialNumber: ABCD
After executing the procedure to makes the LPC-Link 2 compatible with J-Link LITE described here:
segger.com/products/debug-prob…other-j-links/lpc-link-2/
Now the LPC-Link-2 probe enumerate on the USB bus in the DFU mode with the following information:
idVendor=1366, idProduct=0101
Product: J-Link
Manufacturer: SEGGER
SerialNumber: 000611000000
This make the LPC-Link-2 probe unable to work with the LPCScrypt application: the probe in not even detected into the LPCScrypt boot procedure.
How can I revert the LPC-Link-2 to his factory state, enumerating LPC, NPX and ABCD in the DFU mode ?
Best Regards.
I own a LPC-Link-2 probe that initially enumerate on USB bus in DFU mode with the following information:
idVendor=1fc9, idProduct=000c
Product: LPC
Manufacturer: NXP
SerialNumber: ABCD
After executing the procedure to makes the LPC-Link 2 compatible with J-Link LITE described here:
segger.com/products/debug-prob…other-j-links/lpc-link-2/
Now the LPC-Link-2 probe enumerate on the USB bus in the DFU mode with the following information:
idVendor=1366, idProduct=0101
Product: J-Link
Manufacturer: SEGGER
SerialNumber: 000611000000
This make the LPC-Link-2 probe unable to work with the LPCScrypt application: the probe in not even detected into the LPCScrypt boot procedure.
How can I revert the LPC-Link-2 to his factory state, enumerating LPC, NPX and ABCD in the DFU mode ?
Best Regards.