Problem with setting BMI value of Infineon XMC1000 via J-Link

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Problem with setting BMI value of Infineon XMC1000 via J-Link

    I'm trying to set boot mode index of new MCU on the target board to SWD1(P1.2 and P1.3) from ASC_BSL mode. After debugging I want change it to user productive mode.
    All connections are without errors, MCU supplied.
    But J-Link commander can't establish connection.

    I connect manually SWD to P0.14 and SWCLK to P0.15 (SWD0 mode) and now can debug target, but can't change BMI to preferred.
    GetBMI and SetBMI commands returns error code -262, DAVE4 and XMC Flasher can't get BMI too.
    DLL version V6.30i
    Firmware: J-Link V10

    How can I change it?

  • Hello,

    your request has been received by e-mail as well and will be discussed there further.
    This thread will be closed now.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.