Hi,
I need some help reading/writing the external flash chips connected to a SPEAR600.
I have a dev. setup using an ST-Micro SPEAR600 processor, using it's JTAG interface with my J-Link. The SPEAR600 is in your supported processors list, but currently cannot program either external flash chip. The SPEAR600 has an external serial NOR interface, as well as an FSMC NAND flash interface.
I can't seem to find the documentation anywhere on how to actually configure the FSMC, it's mentioned in the spear600 datasheet, but no info on the actual bit fields, etc.
I'm flexible with what tools to use, currently I have IAR EWARM, but am fine using your JFLASH as well....
Is this something you are able to help with? Have you done any scripts or project setups with the SPEAR600 before??
(I believe the NAND interface is ONFI?)
Thanks so much for any help you can provide!
- Mike
I need some help reading/writing the external flash chips connected to a SPEAR600.
I have a dev. setup using an ST-Micro SPEAR600 processor, using it's JTAG interface with my J-Link. The SPEAR600 is in your supported processors list, but currently cannot program either external flash chip. The SPEAR600 has an external serial NOR interface, as well as an FSMC NAND flash interface.
I can't seem to find the documentation anywhere on how to actually configure the FSMC, it's mentioned in the spear600 datasheet, but no info on the actual bit fields, etc.
I'm flexible with what tools to use, currently I have IAR EWARM, but am fine using your JFLASH as well....
Is this something you are able to help with? Have you done any scripts or project setups with the SPEAR600 before??
(I believe the NAND interface is ONFI?)
Thanks so much for any help you can provide!
- Mike
The post was edited 1 time, last by MikeFlyersFan ().