[ANSWERED/SOLVED]J-Link FlashBP and Crossworks ARM

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ANSWERED/SOLVED]J-Link FlashBP and Crossworks ARM

    Hi,

    I have the J-Link non commercial version with software 4.12 .
    I work with Crossworks ARM V 2.0.5,but the FlashBP does'nt work.
    I get the folloing message "Cannot single step: Not enough hardware breakpoints".
    The J-Link RDI config I also configured!

    What can I do?

    Thanks

  • Hi mirona,

    We have tested this with J-Link version 4.13g + Rowley's Crossworks v2.0.5
    and we did not get any errors - everything works fine as you can see on the
    screenshot below.

    By the way, the flash breakpoints are set by the Crossworks IDE directly and not via the J-Link
    DLL API, so currently the J-Link flash breakpoint technique can not be used with Rowley.


    Best regards,
    Kai
    Images

    • FlahBP.png

      406.63 kB, 1,508×895, viewed 1,031 times
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

    The post was edited 1 time, last by SEGGER - Kai ().