I'm using a J-Link base for programming an EFM32 using the embedded Flash program supplied with Simplicity Studio.
From Segger documentation found elsewhere I can see that you should be able to send it any of the following commands....
power on, power off, power on perm & power off perm.
There doesn't seem to be any way to send these from inside the Simplicity Studio Flash program so I presume that means I need to used software supplied by Segger?
Can someone tell me what the software is that I need for this and how to send these commands? There appears to be a bewildering array of downloads so perhaps someone can tell me which one I need to do this job?
From Segger documentation found elsewhere I can see that you should be able to send it any of the following commands....
power on, power off, power on perm & power off perm.
There doesn't seem to be any way to send these from inside the Simplicity Studio Flash program so I presume that means I need to used software supplied by Segger?
Can someone tell me what the software is that I need for this and how to send these commands? There appears to be a bewildering array of downloads so perhaps someone can tell me which one I need to do this job?