STM32 with SSD1963

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • STM32 with SSD1963

    Hi,


    i'm new and i try to understand the samples from emWin.
    But i understand not the connections between MCU and grafic controller.
    I found in the user manual the different possibility to connect the controller.

    In the case of the online sample i can't say which controller and which mode is used.


    My goal is to connect the SSD1963 controller to a STM32 board.

    For the SSD1963 i think the indirect interface is the correct one.
    33.2.2 Indirect interface - Parallel bus

    Maybe someone can get me a short tip.


    Thanks

    Bernhard
  • Hi,

    The SSD1963 LCD controller is supported by the GUIDRV_FlexColor driver.

    It gets connected by an indirect interface.

    Attached is a sample configuration for the GUIDRV_FlexColor configured to be used for the SSD1963. This configuration uses bit banging but it should be quite easy to use a hardware interface like SPI.

    Regards
    Sven
    Files
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.