I have a product that contains 2x STM32L476xx chips connected via JTAG daisy chain. I have purchased a J-Link Base programmer but am unsure of the proper way to download to and debug both chips at the same time using a single J-Link Base probe.
I am using Eclipse 4.7.0 on OS X w/ the appropriate plugins. I have a working project and am able to download and debug on one of the processors in the chain via a Segger J-Link GDB server debug configuration but I don't see any options to specify different applications and different targets. Can this be done?
I have also played around with Ozone but have not been able to figure out how to get both chips programmed / debugged (again using a single J-Link base probe). I believe this may be possible via the scripting interface but am not sure where to start. Is there a tutorial on this?
If neither of these tools work, what is the preferred method to do this?
I am using Eclipse 4.7.0 on OS X w/ the appropriate plugins. I have a working project and am able to download and debug on one of the processors in the chain via a Segger J-Link GDB server debug configuration but I don't see any options to specify different applications and different targets. Can this be done?
I have also played around with Ozone but have not been able to figure out how to get both chips programmed / debugged (again using a single J-Link base probe). I believe this may be possible via the scripting interface but am not sure where to start. Is there a tutorial on this?
If neither of these tools work, what is the preferred method to do this?