[ABANDONED] J-Flash V618c production programming error

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] J-Flash V618c production programming error

    I was previously using J-Flash V512j without error. I upgraded to V618c and now get the error below using Production Programming (F7).

    ERROR: Timeout while programming sector, RAMCode did not respond in time. (PC = 0xFFFFFFFF, CPSR = 0xFFFFFFFF, LR = 0x61000003)!
    Failed to restore target. RAMCode never stops
    - ERROR: Failed to perform exit steps

    I've attached the jflash file and log file.
    Files

    • Program_Log_V618c.txt

      (4.8 kB, downloaded 420 times, last: )

    • gr.jflash

      (3.79 kB, downloaded 370 times, last: )

  • Hi,


    you are changing the options bytes via the exit steps, not via the data file.
    Therefore, could you please change the selected device from "ST STM32L071RZ (allow opt. bytes)" to "ST STM32L071RZ"?

    Does this work for you?

    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.