Hello guys,
I try to load my program on my ECU using j link but it says that :
WARNING: CPU could not be halted
ERROR: Could not connect to target.
Target connection failed. GDBServer will be closed...Restoring target state and closing J-Link connection...
Shutting down...
Could not connect to target.
Please check power, connection and settings.
but i used the same configuration with a discovery and it works (I've upgraded the st link on the discovery to a j link).
and thank you for your time
I try to load my program on my ECU using j link but it says that :
WARNING: CPU could not be halted
ERROR: Could not connect to target.
Target connection failed. GDBServer will be closed...Restoring target state and closing J-Link connection...
Shutting down...
Could not connect to target.
Please check power, connection and settings.
but i used the same configuration with a discovery and it works (I've upgraded the st link on the discovery to a j link).
and thank you for your time