I have been trying to connect Segger J-link with NXP's MAC57D5. MAC57D5 is not listed among the supported device list, though NXP does mention J-Link base as compatible debug probe for MAC57D5. Though I haven't succeeded in getting them to connect, when I try to debug, I get the following error:
"
****** Error: CPUID register [31:24] does not specify ARM (0x41) as vendor
Found SW-DP with ID 0x5BA02477No AP preselected. Assuming that AP[0] is the AHB-APAP-IDR: 0x64770001, Type: AHB-APAHB-AP ROM: 0xFFFFFFFC(Base addr. of first ROM table)
Cannot connect to target.
"
Any help would be greatly appreciated.
Regards
Asad
"
****** Error: CPUID register [31:24] does not specify ARM (0x41) as vendor
Found SW-DP with ID 0x5BA02477No AP preselected. Assuming that AP[0] is the AHB-APAP-IDR: 0x64770001, Type: AHB-APAHB-AP ROM: 0xFFFFFFFC(Base addr. of first ROM table)
Cannot connect to target.
"
Any help would be greatly appreciated.
Regards
Asad