[SOLVED] J-Link Command-Line "erase if necessary"

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-Link Command-Line "erase if necessary"

    I try to use my J-Link via Command-Line Interface. In the actual version I'm using controller STM AT91SAM7S256-AU-001. There are two possible situations. First the controller is empty, than the programmer should start programming immediately . Second possible situation is, that there are some datas in the controller, so the programmer should delete the controller before programming.
    Is there a command to do this? Something like "Eraseifnecessary"?
    Actual I'm deleting the controller every time before programming. This takes about 25s to do!

    Any hints welcome

    Werner

  • Hi Werner,



    could you please give to most recent version of the J-Link software & documentation pack a try?

    The software does only erase if necessary if not told otherwise per default.

    Could you please provide a screenshot of the settings tab of the J-Link control panel?


    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.