[SOLVED] J-Link Remote Warning "Unknown EMU command #24.."

sailectric · May 17th 2017, 2:51pm

when i try to connect via Remote Tunnel server, the connection between the PCs seem to work.
At least i see "reactions" on the Remote Server PC when i connect via J-Link Commander from the Host PC.
But i got the J-Link Remote Server V6.14h Warning "Unknown EMU command #24 received. Discontinuing parsing of communication." on the J-Link coupled PC.
SW on both PC has been updated to newest (J-Link Remote Server V6.14h) and the J-Link firmware is updated too.
Any proposals?

Best Regards
Uwe

P.S. the same issue appears when i directly use ip connection without tunneling.
Remote server shortly connects and then disconnects due to the "unknown command" issue.

SEGGER - Niklas · May 17th 2017, 3:30pm

Hi Uwe,

this issue occurs with Clients version 6.14c or higher (server version is irrelevant)
It will be fixed in one of the next releases of the software.

Best regards,
Niklas

sailectric · May 17th 2017, 4:50pm

Thank you!!!

profanum429 · Aug 1st 2017, 4:14am

Hi, I've run into this same issue with 6.16j. I was wondering if there is a timeline for a future release with this fixed? Thanks!

SEGGER - Niklas · Aug 1st 2017, 5:32pm

Hi,

this in our internal ToDo.
A version of the J-Link software & documentation pack which fixes this issue is schedules for release later this week / beginning of next week.

Best regards,
Niklas

profanum429 · Aug 2nd 2017, 5:55am

SEGGER - Niklas wrote:

Hi,

this in our internal ToDo.
A version of the J-Link software & documentation pack which fixes this issue is schedules for release later this week / beginning of next week.

Best regards,
Niklas

Excellent news, thanks for the reply!

charliefjohnson · Aug 3rd 2017, 10:47pm

Any chance of a workaround for this ?? I see it frequently.

SEGGER - Niklas · Aug 4th 2017, 9:27am

Hi,

the best workaround is to update to V6.18 of the J-Link software & documentation pack,
since the issue is fixed in V6.18

Best regards,
Niklas

charliefjohnson · Aug 4th 2017, 5:30pm

Thanks. That seemed to fix it.

SEGGER - Niklas · Aug 8th 2017, 9:13am

Hi,

Good to hear that you are all up and running again!

Best regards,
Niklas

Share