I've read through similar issues on the forum but can't seem to find any resolution.
Hardware: J-Link debug probe version 6.0, AT91SAM7S64, Custom Board
Software: J-Flash v4.76a, J-Flash v6.12f
I can connect to the target device, erase, program, and verify using v4.76a. When we updated another work PC, v6.12f was installed on the system and now I am getting a RAM check failed @ addr 0x00202000. The full log is attached below.
There shouldn't be any hardware issues with either my J-Link or my target board, since they work with no issue on the previous software version. Is my J-Link not compatible with the new software version, or is there something else I am missing?
Hardware: J-Link debug probe version 6.0, AT91SAM7S64, Custom Board
Software: J-Flash v4.76a, J-Flash v6.12f
I can connect to the target device, erase, program, and verify using v4.76a. When we updated another work PC, v6.12f was installed on the system and now I am getting a RAM check failed @ addr 0x00202000. The full log is attached below.
There shouldn't be any hardware issues with either my J-Link or my target board, since they work with no issue on the previous software version. Is my J-Link not compatible with the new software version, or is there something else I am missing?