[SOLVED] Problem with SEGGER J-Link Base and RX63N

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Problem with SEGGER J-Link Base and RX63N

    Hello!

    Approximately one and a half years ago, our company has purchased a device SEGGER J-Link Base version 9.3.
    We have used it for programming and debugging our device based on Renesas RX63N.
    Several days ago our company has purchased a device SEGGER J-Link Base version 10.1.
    We update all software (install J-Link Software and Documentation pack for Windows V6.12a, update firmware to version 2016 Sep 1 18:29).

    SEGGER J-Link Base version 9.3 works fine.

    But SEGGER J-Link Base version 10.1 works very strange.
    It return message ***** Error: Failed to prepare for programming.

    What is the difference between them?
    What may well affect the operation of SEGGER J-Link Base version 10.1?

    We use Eclipse IDE for C/C++ Developers for software development
    Files
    • JLinkBase1.txt

      (40.62 kB, downloaded 412 times, last: )
  • Hello,

    you sent us the same request via E-Mail.
    Update for other customers which might have similar issues:
    It turned out that an interface speed which is out-of-spec has been used (15 MHz) while the RX63N series is specified with 10 MHz max. JTAG speed.
    When using a speed within the spec (<= 10 MHz) both J-Links are working as expected.


    Best regards
    Erik
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.