Hello,
I have Segger flasher rx jtag programmer. I am trying to program R5F5631Y MCU. I can program using USB connection and JFlash software. However, I couldnt manage it using stand-alone mode. The console says:
$FW: Entering standalone mode... OK
#STATUS:INITIALIZING
#STATUS:CONNECTING
#ERR255:Cannot connect to CPU. Target interface speed too high?
#ERR255:Error while flashing
I have prepared the config file and download it to the flasher correctly.
is stand-alone mode supported for Flasher RX Renesas R5F5631Y? If so, what is the problem.
Thanks in advance!
I have Segger flasher rx jtag programmer. I am trying to program R5F5631Y MCU. I can program using USB connection and JFlash software. However, I couldnt manage it using stand-alone mode. The console says:
$FW: Entering standalone mode... OK
#STATUS:INITIALIZING
#STATUS:CONNECTING
#ERR255:Cannot connect to CPU. Target interface speed too high?
#ERR255:Error while flashing
I have prepared the config file and download it to the flasher correctly.
is stand-alone mode supported for Flasher RX Renesas R5F5631Y? If so, what is the problem.
Thanks in advance!