JTAG interface on board where TNETC48xx is mounted. Interface picture is shown as below.
[img]http://lh3.ggpht.com/_TgxxPnCluag/SkLVKo7qCeI/AAAAAAAAAGU/s-hmFPyU4PU/s800/jtag_interface.jpg[/img]
The main core of TNETC48xx is ARM11.
I connected the following pins to J-Link respectively
TRST,TMS,TDI,TDO,TCK,GND. And connecting pin 5 of the above picture to pin 1 of J-Link.
After that, I connected to board via J-link, but ARM11 can not be recognized. Error message is reported:
[img]http://lh5.ggpht.com/_TgxxPnCluag/SkLaJY5xXbI/AAAAAAAAAGY/VnCFg6G1qmY/s800/deviceid_error.jpg[/img]
What should I do?
Thank you!
[img]http://lh3.ggpht.com/_TgxxPnCluag/SkLVKo7qCeI/AAAAAAAAAGU/s-hmFPyU4PU/s800/jtag_interface.jpg[/img]
The main core of TNETC48xx is ARM11.
I connected the following pins to J-Link respectively
TRST,TMS,TDI,TDO,TCK,GND. And connecting pin 5 of the above picture to pin 1 of J-Link.
After that, I connected to board via J-link, but ARM11 can not be recognized. Error message is reported:
[img]http://lh5.ggpht.com/_TgxxPnCluag/SkLaJY5xXbI/AAAAAAAAAGY/VnCFg6G1qmY/s800/deviceid_error.jpg[/img]
What should I do?
Thank you!
The post was edited 3 times, last by linuxsir320 ().