[ABANDONED] JLink Base erase error on STM32F429ZI

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] JLink Base erase error on STM32F429ZI

    Hi,
    I'm trying to flash a STM32F29 with a JLINK base probe. I successfully connect to the board, managed to write some registers correctly, but then when I try to do erase or loadbin, I get an error (-5).

    Could you please let me know what this error code means? Could there be a HW issue? But then, I successfully write other flash control registers just fine.

    Thank you,
    Iani

  • Hi Iani,



    Could post the complete output of J-Link Commander of a session, including the initial connect and the loadbin / erase command?


    Best regards,
    Niklas
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.