PIC32 and 4-Wire JTAG

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • PIC32 and 4-Wire JTAG

    Hi,
    I want to use the JLink with the Microchip Explorer 16 board (JTAG 4-Wire).
    So I build an adapter from the 20-Pin header (Jlink) to the 14Pin header from the Explorer Board.
    To test the connection I use the JLink GDB Server Tool (Correct µC choosen), but the tool can't connect (VREF is shown correctly ).
    I checked the connection twice so I think the adapter can't be the problem.
    Has anyone ideas to solve the problem? It is possible to use 4-Wire-JTAG with the PIC32?
    Does the JLink GDB Server work with PIC32?
    Regards
    goech

    The post was edited 1 time, last by goech ().

  • Hi,
    today I've tryed to connect via JTAG with the J-Link Commander V4.96b following message is shown:
    VTarget = 3.312V
    Info: TotalIRLen = ?, IRPrint = 0x..000000000000000000000000
    Info: TotalIRLen = ?, IRPrint = 0x..000000000000000000000000
    On reset commando
    J-Link>r
    Info: TotalIRLen = ?, IRPrint = 0x..000000000000000000000000
    Reset delay: 0 ms
    Reset type UNKNOWN: ???
    Info: TotalIRLen = ?, IRPrint = 0x..000000000000000000000000
    Any Ideas?
    Regards,
    goech