Hi,
I am facing a problem with the MCU model STM32F105RB. I am using it with the J-link EDU.
I use a custom hardware, which works properly with the STM32F205RB model. Now I am trying to use the same custom hardware with the model STM32F105RB, adding the two resistors as stated in the datasheet (see next figure).
[img]https://dl.dropboxusercontent.com/u/60356745/resistors.PNG[/img]
The problem is that when communicating with the MCU via the J-Link Commander, I am getting this error:
[img]https://dl.dropboxusercontent.com/u/60356745/commander.PNG[/img]
I have also read in this forum that to unlock the MCU it is also necessary to use first the J-Link STM32 Unlock, but it trhows the following error.
[img]https://dl.dropboxusercontent.com/u/60356745/unlock.PNG[/img]
Thanks in advance
I am facing a problem with the MCU model STM32F105RB. I am using it with the J-link EDU.
I use a custom hardware, which works properly with the STM32F205RB model. Now I am trying to use the same custom hardware with the model STM32F105RB, adding the two resistors as stated in the datasheet (see next figure).
[img]https://dl.dropboxusercontent.com/u/60356745/resistors.PNG[/img]
The problem is that when communicating with the MCU via the J-Link Commander, I am getting this error:
[img]https://dl.dropboxusercontent.com/u/60356745/commander.PNG[/img]
I have also read in this forum that to unlock the MCU it is also necessary to use first the J-Link STM32 Unlock, but it trhows the following error.
[img]https://dl.dropboxusercontent.com/u/60356745/unlock.PNG[/img]
Thanks in advance