Hi guys,
I'm using JFlashARM.exe in command line with these options :
The programming is OK, but the STM32F407VE never boot after that. JFlash say that the application is started. I must unpower and power again to start the board.
I have the same problem with STM32F103VE.
I'm using the latest version of JFlashARM (4.80) and JLink v8.0
The project file is attached and here is the log from JFlashARM:
Best regards
Patrick
I'm using JFlashARM.exe in command line with these options :
The programming is OK, but the STM32F407VE never boot after that. JFlash say that the application is started. I must unpower and power again to start the board.
I have the same problem with STM32F103VE.
I'm using the latest version of JFlashARM (4.80) and JLink v8.0
The project file is attached and here is the log from JFlashARM:
Many thanks for your helpConnecting ...
- Connecting via USB to J-Link device 0
- J-Link firmware: V1.20 (J-Link ARM V8 compiled Nov 25 2013 19:20:08)
- JTAG speed: 4000 kHz (Fixed)
- Initializing CPU core (Init sequence) ...
- Executing Reset (0, 0 ms)
- Initialized successfully
- JTAG speed: 4000 kHz (Fixed)
- Connected successfully
Auto programming target (195504 bytes, 1 range) ...
- Unsecure chip ...
- Disconnecting ...
- Disconnected
- Connecting via USB to J-Link device 0
- Chip unsecured successfully
- Erasing affected sectors ...
- Connecting ...
- Connecting via USB to J-Link device 0
- J-Link firmware: V1.20 (J-Link ARM V8 compiled Nov 25 2013 19:20:08)
- JTAG speed: 4000 kHz (Fixed)
- Initializing CPU core (Init sequence) ...
- Executing Reset (0, 0 ms)
- Initialized successfully
- JTAG speed: 4000 kHz (Fixed)
- Connected successfully
- 6 of 8 sectors affected, 1 range
- Affected sectors 0 to 5 (0x8000000 - 0x803FFFF)
- RAM tested O.K.
- Erase operation completed successfully
- Programming target (195504 bytes, 1 range) ...
- Target programmed successfully
- Verifying CRC of affected sectors ...
- 6 of 8 sectors affected, 1 range
- Affected sectors 0 to 5 (0x8000000 - 0x803FFFF)
- CRC of affected sectors verified successfully (CRC = 0x3706E77B)
- Secure chip ...
- Chip secured successfully
- De-initializing CPU core (Exit sequence) ...
- De-initialized successfully
- Target erased, programmed and verified successfully - Completed after 19.634 sec
- Starting application ...
- Disconnecting ...
- Disconnected
- Connecting via USB to J-Link device 0
- Target application started
Best regards
Patrick