Part Number: ATSAM4LC4B
Development Environment: AtmelStudio 6.1 (GNU gcc) + J-Link (JTAG) + custom board
Hello.
"Cycle Counter" and "Stop Watch" (Processor tab) are always zero during debugging.
CycleCnt is always zero also in J-Link's Contol panel ("CPU Regs" tab), while debugging via Atmel Studio (J-Link is connected as JTAG).
But if the J-Link's console (J-Link Commander) is used (instead of the Atmel Studio), then the CycleCnt alters on go/halt, but not on single-stepping.
Please help!
Thank you in advance.
Development Environment: AtmelStudio 6.1 (GNU gcc) + J-Link (JTAG) + custom board
Hello.
"Cycle Counter" and "Stop Watch" (Processor tab) are always zero during debugging.
CycleCnt is always zero also in J-Link's Contol panel ("CPU Regs" tab), while debugging via Atmel Studio (J-Link is connected as JTAG).
But if the J-Link's console (J-Link Commander) is used (instead of the Atmel Studio), then the CycleCnt alters on go/halt, but not on single-stepping.
Please help!
Thank you in advance.