JLink v4.76 Target connection issue

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • JLink v4.76 Target connection issue

    JLink v4.76 gives an error about Target connection,

    ""


    The debug instrument IO could not be initialized.


    The GDI debug instrument provided the following error message.


    An error occurred while connecting to the target. The exact cause is unknown, but possibly, the J-Link is not connected to the target properly.""



    Note: JLink v4.76 used with DAVE to connect Infineon XMC1 devices.

    The post was edited 1 time, last by Raj DAVE ().

  • Hi,

    As already discussed via e-mail through official support channel:
    Please use V4.76a which fixes the problem.


    Best regards
    Alex
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.