Tuesday, March 20th 2018, 11:58pm UTC+1

You are not logged in.

  • Login
  • Register

Dear visitor, welcome to SEGGER Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Date of registration: Jun 19th 2013

Posts: 3


Thursday, June 20th 2013, 1:55pm

J-link connection with embOSView using RPBRX62N

Dear users,

I work in project and we use RPBRX62N board from Renesas with SEGGER Eval Software for RPBRX62N. I run project called 'Start_RX62N'. I understand that I should use embOSView tool for system analysis. embOSView provides several ways to connect (Setup->Communication). This is UART, J-Link ARM7/9/11 and J-Link Cortex-M3. In my case I use RPBRX62N board and I don't use COM port (I use USB and Ethernet Port). Therefore, if I understand correctly, I need yo use J-Link for connection. But how I can configure it? What settings actually I need? Thanks.


Super Moderator

Date of registration: Dec 18th 2007

Posts: 1,516


Monday, June 24th 2013, 7:01pm


This is more embOSView related than really J-Link.
J-Link supports memory accesses to RX. Regarding the status of embOSView + J-Link + RX I am not sure if I am fully up-to-date since embOSView is maintained by the embOS guys.
I will check.

Best regards