Using:
Jlink Ultra+
Jlink SW v612
IAR Workbench 7.60
FreeRTOS v9.0.0
AT91SAM7X128 with PLL Clock selected for 48Mhz.
In IAR Workbench Under Options->Debugger->Jlink/Jtrace->JTAG/SWD speed is set to Auto, Intial 32 Khz.
Running a board with multiple blinking LEDs. With the debugger running the LEDs run much slower. With the debugger NOT running LEDs are blinking at the correct rate. The datasheet for the Jlink Ultra+ says, "Maximum target interface speed 50 MHz".
What am I missing? Missing/Wrong debugger setting?
Thanks,
Brian
Jlink Ultra+
Jlink SW v612
IAR Workbench 7.60
FreeRTOS v9.0.0
AT91SAM7X128 with PLL Clock selected for 48Mhz.
In IAR Workbench Under Options->Debugger->Jlink/Jtrace->JTAG/SWD speed is set to Auto, Intial 32 Khz.
Running a board with multiple blinking LEDs. With the debugger running the LEDs run much slower. With the debugger NOT running LEDs are blinking at the correct rate. The datasheet for the Jlink Ultra+ says, "Maximum target interface speed 50 MHz".
What am I missing? Missing/Wrong debugger setting?
Thanks,
Brian