Sunday, February 18th 2018, 8:37pm UTC+1

You are not logged in.

  • Login
  • Register


Dear visitor, welcome to SEGGER Forum. If this is your first visit here, please read the Help. It explains how this page works. You must be registered before you can use all the page's features. Please use the registration form, to register here or read more information about the registration process. If you are already registered, please login here.

Message information
Automatically converts internet addresses into links by adding [url] and [/url] around them.
Smiley code in your message such as :) is automatically displayed as image.
You can use BBCode to format your message, if this option is enabled.
Security measure

Please enter the letters that are shown in the picture below (without spaces, and upper or lower case can be used).

The last 4 posts

Wednesday, February 14th 2018, 12:05pm

by SEGGER - Nino



Does this mean you cannot get output of those commands in Ozone 's console .. ?

The Ozone log will log everything that you see and enter in the Ozone Console.

Most commands you see in the action table of the Ozone user manual will not print any return value in the Console as they are meant to be used with the Ozone scripting interface.
For memory reads and writes while debugging we suggest using the memory window.

Best regards,

Tuesday, February 13th 2018, 12:18pm

by v01d

Does this mean you cannot get output of those commands in Ozone 's console .. ?
(Same as with JLink commander : read memory, it prints output ).

Did not plan to log anything ..

Monday, February 12th 2018, 5:14pm

by SEGGER - Nino


Thank you for your inquiry.

To enable Ozone log do the following:
launch "Ozone --logfile <logfile>" where <logfile> is the logfile path. More information are available in the Ozone manual.

Best regards,

Sunday, February 11th 2018, 6:55am

by v01d

Getting output from user actions in Ozone

Is it possible to get the output of the User Actions command inside Ozone?

E.g. I do Target.ReadU32( 0x80000004) .

When I do this from Ozone's Console window, command seems runs, but I get no output. Is there special window .. ?